Extrusion, Complete Systems, Multi Layer
Together.Creative.Innovative.Successful
Our systems
Good reasons for... Bellaform
For your products

Pull Cutter 2020 - Take Off and Cutter

Take Off

  • Synchronous distance spacing of the upper and lower carts (for consistent product centre)
  • No influence of the weight on the pressure - “Weightless upper and lower carts“
  • Diameter changes to the product will cause the upper and lower carts to “deflect“ to prevent damage to the belts.
  • Belt pressure can be set
  • Take-off belts in the usual Bellaform design
  • Side guidance of the product by rollers. The roller distance can be set with a handwheel at the roller guide.
  • Servo drive – with a motor
  • Direct drive without toothed belt
  • Inner protective cover for visual (and mechanical) of the belt area

Technical Details - Take Off

Take-off length (mm)

600

Width (mm)

40/80

Belt distance (mm)

0-50

Speed (m/min)

10-300

Drive output of the servo motor

2kW

Options - Take Off

  • Belt spacing adjusted electromechanically with measurement and display of the spacing
  • Passage monitoring of the product with a counting wheel
  • Quick opening – in case of fault, the lower and upper carts move to max. distance
  • Belt distance setting – automatic setting from the product list (in combination with BELLEX)
  • Pressure of the belts – automatic setting from the product list (in combination with BELLEX)
  • Belt tensioned pneumatically – automatic setting from the product list
    (in combination with BELLEX)

Cutter

  • The entire cutting unit can be moved (250 mm) in order to make it easier to thread in the product into the cutting guide.
  • Movement takes place pneumatically with end position Monitoring.
  • The cutting guide can also be replaced as a whole without losing the setting (knife gap or cutting position).
  • The position of the cutting guide is monitored with a proximity Switch.
  • The cutting unit has a double protective cover (with locking switches).
  • In setup mode, the guides on the inlet and outlet sides can be set securely (inner protective cover with latch around the knife beam).
  • Inner cover via adjustment and motor for optimal product guidance 

Technical Details - Cutter

Product diameter (mm)

max. 30

Wall thickness (mm)

max. 2,5

Operating modes

Continuous/Start-Stop 180 °/Start-Stop 300°

Drive output of the water-cooled servo motor

12 kW

 

Options - Cutter

  • Below the cutting guide, an output belt can be installed for the cut product pieces.

Contact Persons

Ansprechpartnerin Brisbois, Bellaform GmbH, Pütz Prozessautomatisierung GmbH, Pütz Group

Mrs. Iris Brisbois (Sales)
Phone: +49 67 25 919 25 33
Fax: +49 67 25 919 25 233
ibrisboisinhalt1zeile12$%@;ednocontent:.h1undh1okbellaform.com

Bellaform GmbH, Pütz Prozessautomatisierung GmbH, Pütz Group, Ansprechpartner Langer

Mr. Frank Langer (Operational Management)
Phone: +49 67 25 919 25 36
Fax: +49 67 25 919 25 236 flanger@bellaform.com

Member of Member of Pütz Group © 2018 Bellaform GmbH